Advertisement
KORE 2 also provides a means for assigning multiple parameters to a single
C
on a C
ontroller
ontrol
button to multi-assign-mode. If you then use the Learn function you can
assign multiple parameters. Just click them on the interface to add them
to the d
l
eStination
aBel
The third button of the a
will detect the lower and upper limit of you moving the destination
parameter during assignment. This will automatically be set as the control
range for the respective parameter. You can also alter this manually
afterwards (see below).
To delete unwanted destinations, simply click on the d
buttons to the right of the d
The r
a
elatiVe
SSignMent
assigned parameters. This applies only if one of the parameters is moved
"directly" i.e. not via the C
the KORE 2/plug-in interface.
For example: You have two different parameters – cutoff and resonance of
the MASSIVE plug-in – assigned to the same C
►
Without r
mode, both parameters will always display the exact
elatiVe
position of the Controller Knob.
►
If the r
mode is activated and you adjust the resonance on
elatiVe
Massive's plug-in interface, the C
resonance setting through its complete range but keep the difference
it has to the cutoff setting.
P
. The M
a
age
ulti
SSign
d
on the right side of the C
iSPlay
t
is the r
SSign
aB
ange
l
.
eStination
aBelS
mode is for keeping the relative position of multiple
P
but by using the parameter dial on
ontrol
age
ontroller
switch toggles the Learn
t
.
ontrol
aB
a
. If active, KORE 2
SSign
r
eStination
eMoVe
K
:
ontroller
noB
K
will not move the
noB
%
Don't be confused that
the Assign Tab does not
work for Pages other than the User
Pages. Channel and Plug-in Pages
are not editable.
KORE 2 – 90
Advertisement
