Native Instruments O Kore 2 Operation Manual page 155

3.8.15 Gate
Apart from the classic studio use as a noise gate, this effect has a large
number of application areas including chopping up beats using the filter
for gating defined frequency ranges.
Label
Controls the balance between the dry, unprocessed signal (at the left) and the wet, pro-
Mix
cessed signal (at the right).
Detector Filter Cutoff frequency of the 2-pole high pass filter of the level detector. Can be used to avoid
Low Cut opening of the gate by low frequencies.
Detector Filter Cutoff frequency of the 2-pole low pass filter of the level detector. Can be used to avoid
Hi Cut opening of the gate by high frequencies.
Threshold Sets the level at which the Gate opens.
Hysteresis Determines by how much the threshold for closing is lower than the threshold for opening.
Attack Sets the time it takes for the gate to open.
Hold Controls the time the gate will stay open, regardless of the signal falling below threshold.
This is the time the Gate takes to close completely after the signal has fallen below
Release
threshold.
Function Range Unit
0..100 %
10...5000 Hz
100..20000 Hz
-80..10 dB
0..20 dB
0..200 ms
0..1000 ms
0..2000 ms
KORE 2 – 155