Advertisement
this works independently from the t
button you can also transpose the sequence in normal run mode.
The C
menu has three different entries:
loCKSynC
►
None causes the S
teP
without syncing the switch time to the global or host clock. This also
means that it can run without KORE 2's master clock or the host clock,
respectively, being active.
►
With Beat selected the S
the global or host clock.
►
When Bar is selected, the S
first beat of the next bar.
The Time section
On the left side of the t
of settings ranging from 1 for whole notes to 6 for 6th notes. The
values are equivalent to the grid spacing of the sequencer, so with a r
setting of eight the sequencer will advance one step every eighth of the
global/host clock.
The
and
triPletS
dotted
dotted or triplets. These two parameters can only work alternatively,
not both at the same time. They result in the following changes in grid
length:
►
A
note adds the half of the note value (as defined by r
dotted
you have a r
of 2 (for half notes) the dotted option leads to a grid
ate
spacing of three beats length.
setting. With an active t
rigger
S
to switch to the new track immediately,
eQuenCer
S
will switch on the next beat of
teP
eQuenCer
S
will switch playback on the
teP
eQuenCer
section sits the r
iMe
ate
buttons change the grid of the played notes to
ranSPoSe
menu. It offers a choice
ate
). If
ate
KORE 2 – 201
Advertisement
