Removing The Sas Raid Hdd Module; Required Tools; Preliminary Steps - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
7.2.3

Removing the SAS RAID HDD module

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
7.2.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing SAS RAID HDD module: tool-less
●
7.2.3.2

Preliminary steps

Before removing the SAS RAID HDD module card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
BX920 S4
94.
66.
52.
53.
Upgrade and Maintenance Manual
Expansion cards and backup units
93.
67.
45.
"Enabling
"Performing a RAID
"Disabling BitLocker
"Disabling boot
"Opening the rack
"Locating the
"Shutting down the
147