Removing And Installing A Pci Expansion Card - Gateway 9415 User Manual

8
Line up the screws on the riser assembly with the slot and large hole in the
replacement PCI riser connector.
9
Press and hold the blue riser locking lever, then place the PCI riser connector onto
the retention pins.
10
Slide the PCI riser connector toward the right to lock it into place, then release the
blue lever.
11
Follow the instructions in
12
Replace the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
13
Follow the instructions in
14
See the card's documentation for software installation instructions.

Removing and installing a PCI expansion card

To remove and install a PCI expansion card:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in
3
Disconnect any cables that are attached to the card you are removing.
"Removing and installing a PCI expansion card" on page
69.
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
www.gateway.com
"Removing and
44.
41. Make
42.
73.
73