The Vlan Command - GE Multinet 4 Instruction Manual

THE CLI AND PROTOCOL MONITOR
Command
set
show
Command
add
delete
edit
5–24
Table 5–16: CLI terminal Commands
Synopsis
set lines | paging
show

5.2.2.15 The vlan Command

The table below explains the commands available for viewing and managing VLANs when
the MN4(vlan)# prompt is displayed or from the MN4# prompt using a
For example:
MN4# vlan add vid 22 name substation_22
or
MN4vlan)# show all ports
Table 5–17: CLI session Commands
Synopsis
add vid n name vlan_name
delete vid n
edit vid n name new_name
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Description
Control the display of the CLI terminal.
Available parameters are:
• – Where n is a number in the range of 1 -
lines n
100. This is the maximum number of lines to
display in the terminal window on execution of a
CLI command.
Default value = 24
• – Control scrolling in the CLI terminal
paging y|n
window:
If y is specified output will display one
—
"page" at a time; that is the scrolling of
information will pause at the number of
lines specified by the lines parameter and
resume after a key is pressed.
If n is specified output will scroll to the
—
screen without pausing until command
output is complete.
Show lines and paging settings.
Add a VLAN with VID
and the name
vlan_name
characters).
Delete the VLAN identified by VID n.
Change the name of the VLAN identified by VID
the name specified in
characters).
prefix.
vlan
Description
(a number in the range 1 -4094)
n
(up to 24 printable
(up to 24 printable
new_name
to
n