Radius: Servers - GE Multinet 4 Instruction Manual

SYSTEM ADMINISTRATION
4–104
The table below describes the parameters you can configure in the RADIUS: Global Settings
screen.
Field Name
Authentication The UDP port used to communicate to the RADIUS server that is
Port:
configured for authentication.
Default value = 1812
Valid Range = 0 - 65536
Challenge Type: The protocol to be used when validating user credentials. It can
take the following values:
User This parameter determines whether the system uses its own
Authentication
local user database or a RADIUS server for authentication. It
Control:
can take the following values:
Default Privilege This parameter determines the default privilege level assigned
Level:
to a user when a RADIUS server does not provide vendor-
specific attributes. It can take the following values:

4.8.6.2 RADIUS: Servers

This page enables you to configure multiple, redundant Remote Authentication Dial-In
User Service (RADIUS) servers.
For more about RADIUS see 6.5.4 RADIUS Support.
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
CHAPTER 4: SYSTEM ADMINISTRATION
Table 4–66: RADIUS: Global Settings
Field Value
• PAP – Username/password sent in the clear (default).
• CHAP – Uses challenge and MD5 hash.
• Local Database – use the local user database (default).
• RADIUS – use a configured RADIUS server.
• No Access (default)
• Read-Only
• Read-Write
• Administrator