Firmware Upgrade - GE Multinet 4 Instruction Manual

Multi-port serial server & managed switch
Table of Contents

Advertisement

CHAPTER 3: ENERVISTA MULTINET4 SETUP SOFTWARE
3.8

Firmware Upgrade

Note
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
The Enervista Multinet4 Setup software or the Web interface or CLI interface or can be
used to upgrade the firmware for the Multinet4. The EnerVista Multinet4 Setup software is
the preferred method because it is much less error prone.
1.
Click on "Upgrade Firmware" under Maintenance through the Site List tree as
shown below.
2.
An Open File window will open to allow the user to browse and choose the
new firmware binary file.
3.
Choose the desired file and then click the Open button to continue.
4.
The uploading status is showing with the progress bar on the bottom of the
main window.
5.
Wait until this process complete and then click the Quick Connect to refresh
the firmware revision.
Please refer to Chapter 4 Administration Tasks section for more Information about
firmware upgrade from the Web Administration Interface.
[Please refer to Chapter 5 for more Information about firmware upgrade from the CLI
Interface.]
ENERVISTA MULTINET4 SETUP SOFTWARE
3–11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents