The Session Command - GE Multinet 4 Instruction Manual

CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Command
show
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
Table 5–11: CLI rstp Commands
Synopsis
show param...
For more information see the description of RSTP functionality in section 4.4.3: RSTP and in
section 6.3: RSTP.

5.2.2.10 The session Command

The table below explains the commands available for managing sessions when the
MN4(session)# prompt is displayed or from the MN4# prompt using a
For example:
MN4# session set timeout 30min
or
MN4(session)# show active
THE CLI AND PROTOCOL MONITOR
Description
Display information about the settings or status of the
bridge or ports.
The available parameters are:
• bridge settings – Display information about
bridge RSTP settings.
• bridge status – Display information about bridge
RSTP status.
• all port settings – Display information about
the RSTP settings of all ports.
• all port status – Display information about the
RSTP status of all ports.
• show port portnum settings – Display
information about the RSTP settings of the
port identified by portnum.
• show port portnum status – Display information
about the RSTP status of the port identified by
portnum.
prefix.
session
5–17