GE Multinet 4 Instruction Manual page 192

THE CLI AND PROTOCOL MONITOR
Command
set
5–16
Table 5–11: CLI rstp Commands
Synopsis
set bridge | port
portnum params...
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Description
Specify RSTP settings for a bridge or port, where
is an Ethernet port designated E1, E2, etc.
The available bridge parameters are:
• – Specify the maximum age of STP
age n
information before discard in a range of 6 - 40
seconds.
•
cstyle 16-bit | 32-bit
cost style or 32-bit (RSTP) cost style.
• – Specify a delay before forwarding state or
delay n
topology change information in a range of 4 -
30 seconds.
• – Specify interval between transmission of
hello n
configuration BPDUs.
•
mode enable | disable
RSTP on this bridge.
• – Specify a priority value for this bridge
priority n
in the range of 0 (highest priority) to 65535,
The available port parameters are:
•
mode edge | legacy | point | auto
Specify one of the following modes:
– For an RSTP-enabled port
— edge
connected to an end system.
– For a port that uses STP only.
— legacy
– For an RSTP-enabled port
— point
connected to another switch.
– The port automatically
—
auto
determines the correct mode based on
received BPDUs.
portnum
– Specify 16-bit (STP)
– Enable or disable
–