Configuration; Configuration: Files - GE Multinet 4 Instruction Manual

CHAPTER 4: SYSTEM ADMINISTRATION

4.2.11 Configuration

MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
The Configuration: Files and the Configuration: Defaults screens shown below, allow you to
make system-wide changes by installing a new system configuration file or by returning to
factory defaults.

4.2.11.1 Configuration: Files

This screen enables you to install and manage configuration files.
When the system is shipped from the factory, it contains a single current configuration file
with factory default values called "config0.xml". Subsequent configuration files will contain
the administrator's saved settings.
FIGURE 4–21: Administration: Configuration: Files
The table below describes the tasks you can perform in the Configuration Files screen.
Field Name
File: To install a configuration file:
Browse: Browse to select a configuration file on your local system.
Upload: Click this button to make the file specified in pathname the
"Current" configuration file. If the configuration is valid the
system is reconfigured according to the contents of the file.
Table 4–22: Configuration Files
Field Value
The Install Form
1. Browse to a file on you local system, or enter the full
path name of a configuration file.
Upload
2. Click .
SYSTEM ADMINISTRATION
4–31