The System Command; The Terminal Command - GE Multinet 4 Instruction Manual

CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Command
set
show
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL

5.2.2.13 The system Command

The table below explains the commands available for basic system information
management when the MN4(system)# prompt is displayed or from the MN4# prompt
using a prefix.
system
For example:
MN4# system set location North Andover
or
MN4(system)# show
Table 5–15: CLI system Commands
Synopsis
set name | location
| contact
show addresses
For more information see the description of basic system information management in
section 4.2.2: System Information.

5.2.2.14 The terminal Command

The table below explains the commands available for terminal settings when the
MN4(terminal)# prompt is displayed or from the MN4# prompt using a
These commands enable you to control the display of CLI command output in your virtual
terminal window.
For example:
MN4# terminal set lines 18
or
MN4(terminal)# show
Description
The available parameters are:
• – Where sysname is a name for the
name sysname
system under configuration.
•
location placename
name of the place where the system under
configuration is located.
•
contact identinfo
or contact information for a person responsible
for management of the system under
configuration.
Display basic system information.
THE CLI AND PROTOCOL MONITOR
– Where placename is the
– Where identinfo is a name
terminal
prefix.
5–23