GE Multinet 4 Instruction Manual page 198

THE CLI AND PROTOCOL MONITOR
5–22
MN4
# sw show
Filename
dx800v140rc3.elf
dx800v140rcQ.elf
Upgrade State: READY TO UPGRADE
FIGURE 5–7: CLI: sw show command output - READY TO UPGRADE
5. Perform the upgrade.
In the CLI command window enter the command sw upgrade. Confirm that you want to
carry out the upgrade by answering yes to the "are you sure" question.
6. Reconnect to the CLI.
After the upgrade command has been issued your connection to the CLI will probably be
lost. Reconnect and run the sw show command.
MN4
# sw show
Filename
dx800v140rc3.elf
dx800v140rcQ.elf
Upgrade State: UPGRADING
FIGURE 5–8: CLI: sw show command output - UPGRADING
7. Finalize.
Complete the upgrade procedure by entering the sw finalize command to approve the
new software image. Run the sw show command one last time to confirm the new
configuration.
MN4
# sw show
Filename
dx800v140rcQ.elf
dx800v140rc3.elf
Upgrade State: UPGRADED
FIGURE 5–9: CLI: sw show command output - UPGRADED
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Version
1.4.0
1.4.0
Version
1.4.0
1.4.0
Version
1.4.0
1.4.0
Use
Current
New
Use
Fallback
Current
Use
Current
Fallback