CHAPTER 3: ENERVISTA MULTINET4 SETUP SOFTWARE
3.5
Connecting to the Multinet4
Note
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
1.
After Device Setup or Quick Connect completed, a site list tree will show on the
left side of the EnerVista Multinet4 Setup window.
2.
In this example, Ethernet port setting window will open by clicking the
Ethernet under Setting > Ports as shown below:
3.
The Ethernet window will open with a status indicator on the lower left of the
EnerVista Multinet4 Setup window.
4.
If the status indicator is red, verify that the Ethernet network cable is properly
connected to the Ethernet port of the Multinet4 and that the IP address on
both sides has been properly setup for communications (steps described
earlier).
Please refer to the EnerVista Multinet4 Setup Help File for more information about the use
of the EnerVista Multinet4 Setup software interface.
ENERVISTA MULTINET4 SETUP SOFTWARE
3–7