Radius; Radius: Global Settings - GE Multinet 4 Instruction Manual

CHAPTER 4: SYSTEM ADMINISTRATION
4.8.6

RADIUS

MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
The table below specifies the parameters you can view and edit in the Security: CLI screen.
Field Name
CLI Mode: Specify whether or not the server accepts non-secure telnet
connections. This parameter takes the following values:
Default value = SSH only
SSH Server State: Indicates the current state of the SSH server process:
The RADIUS screens enable you to add and configure Remote Authentication Dial-In User
Service (RADIUS) servers.
For more about RADIUS see 6.5.4 RADIUS Support.

4.8.6.1 RADIUS: Global Settings

This page enables you to configure global Remote Authentication Dial-In User Service
(RADIUS) parameters.
For more about RADIUS see 6.5.4 RADIUS Support.
FIGURE 4–65: Security: RADIUS: Global Settings
Table 4–65: CLI
Field Value
• Allow Telnet – The server accepts requests on port 23
(Telnet) or on port 22 (SSH).
• SSH Only – The server will only allow connections over
SSH. If a client connects on port 23 that client is
sent instructions to use SSH before the connection
is dropped.
• No Key – No Digital Signature Algorithm (DSA) key has
been generated for the SSH server and therefore it
cannot be started. To start the server, log in to the
CLI and issue the command ssh keygen.
• Running – The SSH server is running normally.
SYSTEM ADMINISTRATION
4–103