Intermec JANUS 2020 User Manual page 299

JANUS 2020 Hand-Held Computer User's Manual
Powering Up or Booting the Reader (continued)
Problem
Other Boot Loader menu messages may
look like this:
Boot Loader
Reboot
Password
Dump
Load
Resume
Storage
Off
Power-On Override
Okay To Resume
20X0A.001
10-6
BC BC
NF
(4MB)NF
Solution
If you see "Bad Saved State," the device may have been in
Storage mode. Press
Storage mode, press
You may also see the "Bad Saved State" message if you press
to suspend the device while it is booting. Press
device. You may be able to save the contents of the physical
RAM drive.
Other self-explanatory messages may display on bottom of the
Boot Loader menu.
For messages in the following group, choose Reboot on the Boot
Loader menu and press
"System Has Reset
Please Reboot"
"Bad CMOS Checksum, Errors
Please Reboot"
"DRAM Check Failed
Please Reboot"
For the messages in the following group, choose Resume or
Reboot on the Boot Loader menu and press
"Keypad Fault Found
Okay to Resume"
"Power-On Override
Okay to Resume"
"Power-Off Timeout, Errors
Okay to Resume"
"Power-Off Forced
Okay to Resume"
to reboot. If you are prompted to exit
again.
.
.
to reboot the