Backspace; Change Configuration - Intermec JANUS 2020 User Manual

Backspace

Purpose: Deletes the last character from the current data record. If there is no data in the
buffer, the reader sounds three low beeps.
From Host: Not supported
Keypad:
IRL Command: Not supported
Scan:
Backspace
*-+*
*-+*

Change Configuration

Purpose: This command must precede any configuration command parameter. If you
enter a valid string, the reader configuration parameters are modified and the
reader sounds a high beep. For help on the configuration parameters, see
Chapter 12, "Configuration Command Reference."
Note: You no longer need to use the Exit Configuration command ($-) after a Change
Configuration command, but it is allowed for backward compatibility.
From Host:
$+ command
Keypad: Not supported
IRL Command: Z"$+command"
Scan:
Change Configuration
*$+*
*$+*
Enter a configuration command or scan a bar code label containing a
configuration command. For example, enter the command BV0 to turn the beep
volume off.
or
BC
NF
Reader Command Reference
11
11-5