Intermec JANUS 2020 User Manual page 14

Code 93 12-27
Code 128 12-28
Command Processing 12-29
Disabling or Enabling Command Override and Enter 12-33
Defining the Reader Commands 12-34
Communications Dock Port 12-35
Communications Port, Select COM Port 12-36
Communications Port, UART Restore 12-37
Communications Protocol 12-38
Configure 12-38
Activate 12-41
Multi-Drop, User-Defined 12-42
Data Bits 12-43
Decode Security 12-44
Display Backlight Timeout 12-44
Display Contrast 12-46
Display Mode, IRL 12-47
Display Setup 12-48
EOF (End of File) 12-52
EOM (End of Message) 12-53
EOR (End of Record) 12-55
Flow Control 12-56
Intercharacter Delay 12-57
Interleaved 2 of 5 12-58
IRL BAK (Bad Program Acknowledge) 12-60
IRL End Program Block 12-61
IRL EOP (End of Program) 12-62
IRL PAK (Program Acknowledge) 12-63
BC
NF
Contents
xiii