Intermec JANUS 2020 User Manual page 141

JANUS 2020 Hand-Held Computer User's Manual (4MB)
5. Insert the card into the drive slot, connector end first with the single-walled
6. Push the card into the drive slot until it fits firmly in the connector at the
7. Close the drive door by sliding the door shut until it latches.
4-8
notch on the right edge of the card.
back of the drive slot.
Note: Do not force a PC card into the drive slot. If the card does not fit easily into
the connector, remove it and make sure you have the card oriented correctly. Then
try again.
Approximately 5 seconds after you insert the card, the reader sounds an
audible beep tone to indicate that it recognizes the card. For a description of
the beep tones, see "Understanding the Reader's Audio Signals" in
Chapter 2.
Note: If you are using a card with an external cable, do not close the drive door.
BC
NF
Single-walled
notch
PC card drive
door
Reader handle
2020U.012