Intermec JANUS 2020 User Manual page 99

JANUS 2020 Hand-Held Computer User's Manual (4MB)
CONFIG.SYS File (continued)
Command Line
[sram]
device=d:\cs.exe /poll:1
device=d:\csalloc.exe
d:\csalloc.ini
device=mtsram.ext
device=mtddrv.exe
[ata]
device=d:\cs.exe /poll:1
device=d:\csalloc.exe
d:\csalloc.ini
device=\atadrv.exe /s:2
device=mtddrv.exe
device=d:\cardid.exe
[flash]
device=d:\cs.exe /poll:1
device=d:\csalloc.exe
d:\csalloc.ini
device=d:\mti1.exe
device=d:\mti2p.exe
device=mtddrv.exe
device=d:\ftl.exe
[io]
device=d:\cs.exe /poll:1
device=d:\csalloc.exe
d:\csalloc.ini
device=mtsram.exe
device=mtddrv.exe
device=d:\cardid.exe
[no]
[common]
device=d:\interlnk.exe /drives:7
/noprinter /com:1 /auto
buffers=10
files=50
stacks=9,256
3-10
BC
NF
Definition
Loads software required for PC cards. CSALLOC is a DOS
program that scans the system for available memory, I/O
port, and interrupt request queue (IRQ) resources.
Loads software required for ATA cards.
Loads software required for flash cards.
Loads software required for SRAM and I/O cards.
Loads Interlnk as a resident device driver only if Intersvr
is executing on a host computer that is connected to the
JANUS device. Do not remove. Auto-Loader uses this line.
Sets the amount of memory that DOS reserves for data
transferred to and from a disk.
Sets the number of files that can be open at one time.
You need this command for IRL support.
Sets the amount of memory that DOS reserves to process
hardware interrupts.