JANUS 2020 Hand-Held Computer User's Manual (4MB)
Communications Protocol, Configure (continued)
Note: If you use User-Defined or Point-to-Point protocol, you should only set the
Timeout Delay command if the baud rate is 9600 or lower. You should disable Timeout
Delay if the baud rate for either of these protocols is set to 19200 or higher.
Point-to-Point
Default:
Syntax:
PSdata
Acceptable values for data are:
0
1
2
3
7
One of these bar codes:
Scan:
User-Defined
*$+PS0*
*$+PS0*
Polling Mode D
*$+PS2*
*$+PS2*
PC Standard
*$+PS7*
*$+PS7*
12-40
User-Defined
Point-to-Point
Polling Mode D
Multi-Drop
PC Standard
BC
NF
Point-to-Point
*$+PS1*
*$+PS1*
Multi-Drop
*$+PS3*
*$+PS3*