Timeout Delay - Intermec JANUS 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual (4MB)

Timeout Delay

Purpose: Defines the length of time the reader waits between characters when receiving
a message. When the timeout expires, an I/O error occurs.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
If you are using User-Defined or Point-to-Point protocol, you should only set the
Timeout Delay command if the baud rate is 9600 or lower. You should disable Timeout
Delay if the baud rate for either of these protocols is set to 19200 or higher.
Default: 10 sec
Syntax: IEdata
Acceptable values for data are:
0
1
2
3
4
5
6
7
8
Scan: One of these bar codes:
No Timeout Delay
*$+IE8*
*$+IE8*
Timeout Delay, 100 ms
*$+IE1*
*$+IE1*
12-92
5 ms
100 ms
500 ms
2 sec
10 sec
20 sec
40 sec
60 sec
No timeout
BC
NF
Timeout Delay, 5 ms
*$+IE0*
*$+IE0*
Timeout Delay, 500 ms
*$+IE2*
*$+IE2*