Intermec JANUS 2020 User Manual page 97

Hide thumbs Also See for JANUS 2020:

Table of Contents

JANUS 2020 Hand-Held Computer User's Manual (4MB)

AUTOEXEC.BAT File (continued)

Command Line

set temp=e:\

set im_errpath=e:\

d:\ipm_4m.exe

REM d:\apm_4m.exe

if exist d:\loaduma.exe d:\loaduma

d:\im_disp.exe

d:\ic /0 e:\janus.ini

d:\kwc.com 0

A temp directory is required for MORE.COM to work

correctly on ROM drives.

Tells the JANUS device to write the configuration error file

JANUS.ERR to drive E. The JANUS device must execute this

command before it calls LOADUMA.EXE.

IPM_4M and APM_4M work with card services to manage

the power on the PC card drive when you suspend and

resume the JANUS device.

Note: Do not load both at the same time, but you must

Loads Reader Services, Configuration Manager TSR, and the

decode and scanner utilities that let the JANUS device

operate as a bar code reader.

Loads software required for the display.

Loads the JANUS.INI configuration file if it exists.

Sets the bar code wedge options. The default configuration

is 0. Configuration parameters are:

0 Virtual wedge and expanded keyboard enabled.

1 Direct Hardware wedge and expanded keyboard

2 Direct Hardware wedge enabled and expanded

keyboard disabled.

3 Virtual Wedge enabled and expanded keyboard

4 Display status.

Loads the RF protocol handler for COM4 only if you are

using a JANUS RF device.