Intermec JANUS 2020 User Manual page 302

Operating the Reader (continued)
Problem
The user application is not receiving the
bar code input properly.
The Battery icon appears at the top of the
reader display.
You see all these symptoms:
• The Battery icon remains on.
• The reader chirps every 5 seconds for
1 minute and then turns off.
• The reader sounds a double-beep
when you enter or scan data, and
sounds a double-click when you press
any key.
CODE39Troubleshooting
nuggethelCODE39 nugget
Solution
Reader Services may have been unloaded. The reader cannot
decode bar code labels unless Reader Services are loaded.
Verify that the IF EXIST D:\RDG.BAT CALL D:\RDG.BAT
command is in AUTOEXEC.BAT, and then warm boot the
reader to reload Reader Services.
If you cannot load Reader Services, you may have assigned too
much conventional memory to the physical RAM drives. For
help, see "Deciding How Much Memory to Use for RAM
Drives" in Chapter 3.
Caution
Do not press any keys while the reader is performing a
warm boot or you may lose data.
Conseil
N'appuyez pas sur des touches pendant que le lecteur se
réamorce, sinon vous pouvez perdre des données.
The reader displays the Battery icon when the NiCad battery
pack has approximately 15 to 45 minutes of power left.
Caution
When the Battery icon appears, save your data and
replace the battery pack as soon as possible.
Conseil
Quand l'icône de la pile apparaît, enregistrez vos données
et remplacez le jeu de piles aussitôt que possible, sinon
vous pourriez perdre des données.
The NiCad battery pack charge is critically low.
Save your data. Replace the battery pack with a spare charged
battery pack, charge the battery pack, or attach an external
power supply.
The laser scanner and RF communications are turned off
15 seconds after the first chirp.
10 10
10-9