Neg (Negative Acknowledge) - Intermec JANUS 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual (4MB)

NEG (Negative Acknowledge)

Purpose:
Default:
Syntax:
Scan:
Or:
12-74
Indicates a negative acknowledgment to a transmitted message. You must
enable both NEG and AFF to have a valid configuration.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Disabled
PHdata
where data can be any ASCII character.
To disable NEG, scan this bar code:
Disable NEG
*$+PH*
*$+PH*
To set NEG to an ASCII character:
1. Scan this bar code:
Enter Accumulate Mode / Set NEG
*+/$+PH*
*+/$+PH*
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
Appendix C.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
BC
NF