Intermec JANUS 2020 User Manual page 168

To create two INI files with different beeper volumes
1. Start IC.EXE, choose the Beeper command from the Op menu, and set the
beeper volume to Quiet.
2. Choose the Save As command from
the File menu and press
Configuration screen appears.
3. Specify a unique DOS filename for
the INI file, such as QUIET.INI.
Make sure the filename includes a
path with a drive that you can write
to, such as drive E:
e:\quiet.ini
Note: If you store the configuration file on drive E, the file will be erased when you
cold boot the reader, load flash memory, put the reader in Storage mode, or execute
CONFIG.SYS after changing the command that creates drive E.
4. Choose Exit from the File menu.
This screen prompts you to update
the online configuration before you
exit.
The online configuration (also called
the current configuration) is the set
of parameters currently enabled on
the reader.
5. Press to choose Yes and apply
the changes to the reader. The
reader now beeps very quietly.
6. Restart IC.EXE, choose Beeper from the Op menu, and change the beeper
volume to Very Loud.
7. Choose Save As from the File menu, and specify a unique DOS filename for
the INI file, such as VERYLOUD.INI.
8. Choose Exit from the File menu. Again, IC.EXE prompts you to update the
online configuration before exiting.
9. Press to select No and press
quietly.
BC
NF
Configuring the Reader
. The
Update online
configuration?
. The reader is still configured to beep
5
Configuration
File Sym Com Op
Load...
Load Default
Save
Save As...
About
Exit
2020U.109
Configuration
Information
Yes No
Cancel
2020U.179
5-11