Intermec JANUS 2020 User Manual page 116

2. Connect a power supply to the communications dock or optical link
adapter.
Note: For JANUS 2010 and 2020 devices only. This step is recommended, but is
not required.
Caution
JANUS 2010 and 2020 devices should be powered by an AC power source
when you use the PutDisk command in case the battery pack goes low
while the flash memory is being overwritten. If the power goes down when
using PutDisk, internal safeguards permit a resume of the flash
programming process. In rare cases, drive C flash must be reloaded from
the Boot Loader menu and you will lose data.
Conseil
Les périphériques JANUS 2010 et 2020 doivent être alimentés par une
source de courant alternatif lors de l'exécution de la commande PutDisk
étant donné le risque de décharge de la batterie pendant que la mémoire
flash est écrasée. Si le courant est coupé pendant l'exécution de PutDisk,
des mesures de sécurité internes font en sorte de remettre en opération le
processus de programmation flash. Il peut arriver, quoique rarement, qu'il
faille recharger la mémoire flash du lecteur C à partir du menu Chargeur-
amorce (Boot Loader) et que des données soient perdues.
3. If you created the image file on the host computer and want to load it to the
JANUS device from the host, start Interlnk now (with the host as server,
and the JANUS device as client).
Note: You can simply reboot the JANUS device after the connected host has
Interlnk installed.
You do not have to start Interlnk if you followed one of these strategies:
• You created the image file on the JANUS device.
• You created the image file on the host computer, copied the file to a PC
card, and inserted the PC card into the JANUS device.
BC
NF
Learning About the Software
3
3-27