Reset Printer - Intermec ESim v4.20 Programmer's Reference Manual

Chapter 7—Commands
^@ – Reset Printer
Description Th is command resets the printer.
Syntax
^@
Remarks Th e ^@-command resets the printer in the same way as a power
off followed by a power on.
• Th e command must be followed by CR/LF to be correctly
interpreted.
• Th e reset command is only available during command input,
that is, not as data in PCX-graphics, soft fonts, or in format
forms.
• Th e printer will be unavailable for a short time during which
all commands sent to the printer will be lost.
Note: An error report has higher priority than other commands
and is processed directly, both in position of normal command-
input and in position of any error recovery.
An ^@ command cannot be performed anywhere else, such as
• during downloading of images, fonts, or forms, or
• inside a variable-input (?) or inside a string-area (""), or
• when the input data buff er is full (> 8000 bytes).
^@ ↵
Example
120 Intermec EasyCoder ESim v4.20—Programmer's Reference Manual
:Printer will be reset.