Chapter 7—Commands
Remarks
Th is command is used in forms that require sequential number-
ing. When initializing counters, they must be defi ned in order
(for example C0, C1, C2, etc.) after possible variables.
To print the contents of the counter, the counter number (C0-
C9) is entered in the "DATA" fi eld of A (Print Text) or B (Print
Bar Code) commands.
Prompts will only be displayed if a UI command has been issued
after last power-up. Th e Keyboard Display Unit sends the UI
command automatically.
Th e fi eld justifi cation parameter (p
will be printed. When p
be printed left, right or center justifi ed in an area with a width
defi ned by p
(p
3
exceed the set maximum fi eld length, which may be useful when
using a counter as input data to a bar code.
If the start value entered, when the form is retrieved for printing,
is started by one or several zeros (0), the entire area specifi ed by
p
(number of digits) will be padded with leading zeros, that is p
2
(fi eld justifi cation) will have no eff ect.
Note: If a single counter is stepped up several times on the same
form, then the step value p
the counter is used in the form or equivalent to what the step
values for the single counter add up to in this form. A Cn±x
command must also be used when designing the actual form. See
the A and B commands.
Th e table below illustrates how leading space characters ("")
in DATA will be infl uenced by next character at wrap around.
If next position is a digit with wrap around (9→0), space will
be incremented to digit 1. If next position is a letter with wrap
around (Z→A), space will be incrementred to letter A.
50
Intermec EasyCoder ESim v4.20—Programmer's Reference Manual
(number of digits). If no justifi cation is selected
2
= N), the fi eld will truncated from the right side so as to not
) aff ects the way the counter
3
= L, R, or C, the counter value will
3
must be set to the number of times
4
3