Intermec ESim v4.20 Programmer's Reference Manual page 53

Th e following QR Code bar code specifi c options should append
the general part of the two-dimensional code command (indi-
cated by italic characters, see b command, general part).
Syntax
bp
1
Parameters c
m
o
s
x
y
"DATA"
Errors If data not suitable to optional parameters: Error 01; Syntax error
If data too long or out of range:
If data does not fi t in area specifi ed
Intermec EasyCoder ESim v4.20—Programmer's Reference Manual
,p ,p , [cn,mn,on,sn,xn,ynn],"DATA"
2 3
Fixed data mode character set:
1 Numerical data mode
2 Alphanumerical data mode
3 8-bit data mode (JIS 0201)
4 Kanji data mode (JIS 0208)
5 Mixing mode (any of mode c1-c4, model type 2)
Default: Model 1
Model 2
Internally during rendering the QR Code, the mode can be switch within a bar
code to minimize the bit stream area. By using parameter cn, the data mode
character set is fi xed.
Model type is defi ned and unchanged within one QR Code.
1 Original version
2 Enhanced version (recommended). Default.
Rotation:
0 0° rotation clockwise. Default.
1 90° rotation clockwise.
2 180° rotation clockwise.
3 270° rotation clockwise.
Sets correction level.
L 7 % Default.
M 15%
Q 25%
H 30%
Masking factor 0-7 or 8 (auto).
Default: 8
Cell pixel size magnifi cation 02-64.
Default: 10
Represents a fi xed data fi eld. Maximum data length is relative chosen model
type and data mode but is limited to approximately 780 bytes. Ordinary string
controls, like \\ for \ and \" for ".
Chapter 7—Commands
Most optimal alternative of c1 to c4
c5
Error 03; Data length
error
Error 50
47