Introduction; Printer Firmware; Installation Kit - Intermec EasyCoder PF4ci Installation Instructions Manual

Preface

Introduction

This Installation Instructions booklet describes how to install a cutter in
an EasyCoder PF4i or PF4i Compact Industrial printer.
The installation instructions also describes how to control the cutter in
Intermec Fingerprint and in Intermec Programming Language (IPL).
This kit must only be physically installed by an authorized
service technician. Intermec assumes no responsibility for
personal injury or damage to the equipment if the installa-
tion in performed by an unauthorized person.
Take precautions against electrostatic discharges, for exam-
ple by wearing grounded bracelets.

Printer Firmware

The printer must be fitted with Intermec Fingerprint v8.00 (or later) or
IPL v2.00 (or later).

Installation Kit

The Cutter Kit contains:
• One cutter unit
• One tray
• Two cables (one for EasyCoder PF4i, one for EasyCoder F4)
• One cable cover
• Three #T20 Torx screws
• Three washers
• One Installation Instruction booklet
The only tool required for the installation is a #T20 Torx screwdriver.
iv Cutter Kit (EasyCoder PF4i-series) Installation Instructions