Introduction; Printer Firmware; Installation Kit - Intermec EasyCoder PM4i Installation Instructions Manual
Cutter kit
Hide thumbs
Also See for EasyCoder PM4i:
- User manual (186 pages) ,
- Installation instructions manual (40 pages) ,
- Safety instructions (24 pages)
Table of Contents
Advertisement
Preface
Introduction
This Installation Instructions booklet describes how to install a cutter in
an EasyCoder PM4i printer.
The installation instructions also describes how to control the cutter in
Intermec Fingerprint and in Intermec Programming Language (IPL).
Printer Firmware
The printer must be fi tted with Intermec Fingerprint v8.00 (or later) or
IPL v2.00 (or later).
Installation Kit
The Cutter Kit contains:
• One cutter unit
• One tray
• Three #T20 Torx screws
• One Installation Instruction booklet
The only tool required for the installation is a #T20 Torx screwdriver.
iv
Cutter Kit (EasyCoder PF4i-series) Installation Instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCoder PM4i and is the answer not in the manual?