Vibrator; Wireless Network Support - Intermec 700 Series User Manual

Chapter 1 — Introduction

Vibrator

Wireless Network Support

18
Note: Each time the 700 Computer is cold-booted, all default settings are
restored.
If your 700 Color Computer is built with an imager or scanner and the
vibrator is disabled, do the following instructions to enable the vibrator. If
you are not able to enable the vibrator, then contact Customer Support.
For information about setting volume levels for screen taps, ActiveSync
alert noises, etc., tap Start → Help → Pocket PC Basics
Notifications.
See Chapter 7, "Programming," to see how to programatically control the
vibrator. See Appendix A, "Configurable Settings," for more information
about the Beeper Volume option.
1 Tap Start → Settings → the System tab → the Data Collection icon to
access its control panel applet.
2 Use the right and left arrows to scroll to the Beeper/LED tab, then tap
this tab.
3 Tap Beeper, select the "Vibrate" option, then tap Apply.
4 Tap ok to confirm this change, then tap ok to exit the Data Collection
control panel applet.
Radios are installed at the factory and cannot be installed by a user. The
700 Color Computer must be serviced to install or replace radios. Contact
your Intermec representative for more information. See Chapter 4, "Net-
work Support" for information about supported radios.
700 Series Color Mobile Computer User's Manual
, then select