Intermec 700 Series User Manual page 267

Resulting Width = Specified Width * Specified Resolution
Resulting Height = Specified Height * Specified Resolution
700 Series Color Mobile Computer User's Manual
Return Values
HRESULT identifying success or error. On error, the following codes will
be returned:
S S_OK
Image successfully returned.
S ITC_RESULT_ERR_BADREGION_E
The specified region is not in the image.
S ITC_RESULT_NO_BC_DECODED_E
A bar code has not yet been decoded or the last bar code decoded was
not a signature capture symbology.
S ITC_IMGBUFF_TOO_SMALL_E
pImgBuffer is too small to contain the signature captured image.
S ITC_INV_PARAMETER_E
One of the parameters is invalid.
S S_DEVICE_NOT_OPENED_E
The device had not been opened.
Remarks
ReadSigCapBuffer() will return the image from the last decoded label with
dimensions identified by the calling parameter. This signature capture
region must include the signature capture bar code. The supported bar
codes for signature capture are: PDF417, Code 128, and Code 39. The
caller specifies the width, height, and center of the image to be retrieved.
This image is independent of any rotation of the bar code relative to the
imager. Thus, if the bar code is decoded with the code itself upside down
to the imager, the retrieved image will still be right side up. However, if
the specified image is outside the field of view a result code of
ITC_RESULT_ERR_BADREGION_E will be returned.
This function uses the dimensions of the last decoded bar code as its coor-
dinate system. Thus, all the parameters describing the image size and posi-
tion are in units called "Intelligent Bar Code Units." An Intelligent Bar
Code Unit is equivalent to the narrow element width of the bar code.
The dimensions of the resulting image can be calculated with this formula:
See Also
None.
Chapter 6 — Scanner Support
245