Intermec 700 Series User Manual page 382
Color mobile computer
Hide thumbs
Also See for 700 Series:
- User manual (418 pages) ,
- Quick start manual (36 pages) ,
- Instructions manual (6 pages)
Table of Contents
Advertisement
Appendix
A
—
Configurable Settings
Action: Tap (+) to expand the Symbology ID parameter, select the EAN 8 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.8.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the EAN 13 user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.9.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the Matrix 2 of 5
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.24.1
Options: x
Action: Tap (+) to expand the Symbology ID parameter, select the Telepen user
SNMP OID: 1.3.6.1.4.1.1963.15.3.3.4.1.25.1
Options: x
360
EAN 8 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify EAN-8 bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is \xFF.
EAN 13 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify EAN-13 (European Article Numbering) bar
code data. Note that this is not available when you use an imager with your
700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is F.
Matrix 2 of 5 User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Matrix 2 of 5 bar code data. Note that this is
not available when you use an imager with your 700 Series Computer.
user ID parameter, then enter a user ID value to change this parameter
setting.
where x is a single ASCII character. Default is D.
Telepen User ID
If "1" was selected in the Symbology ID parameter, you can set your own
ASCII character to identify Telepen bar code data. Note that this is not
available when you use an imager with your 700 Series Computer.
ID parameter, then enter a user ID value to change this parameter setting.
where x is a single ASCII character. Default is an asterisk (*).
700 Series Color Mobile Computer User's Manual
Advertisement
Table of Contents
