Assigning Node Names And Ip Addresses For The Lsps - Avaya G700 Installing Manual

Installing a new G700 with an S8300 using the Avaya Installation Wizard
In this section, you will use the SAT interface to:

Assigning Node Names and IP Addresses for the LSPs

●
Administering Network Regions
●
Associating LSPs with Network Regions
●
Administering IP Interfaces
●
Identifying LSPs to the S8300 primary controller
●
!
CAUTION:
Before continuing, be sure you have saved translations in Communication
CAUTION:
Manager.
Begin by resetting the system.
To reset the System
1. Access the server's command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6.
2. Log in, and open a SAT session (type sat or dsat).
3. At the SAT prompt, type reset system 4
The system reboots.
4. After the reboot is complete, SSH to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type change node-names ip to open the Node Names
screen.
Example Node Names Screen
change node-names ip
Name
default_________
node-10-lsp
node-11-lsp
__________
__________
__________
174 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
IP NODE NAMES
IP Address
0__.0__.0__.0__ _______________
192.168.1 _.50_ _______________
192.168.1 _.51_ _______________
___.___.___. _ _______________
___.___.___. _ _______________
___.___.___. _ _______________
Name
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
Page 1 of 1
IP Address