Upgrading Communication Manager Software; Setting Telnet Parameters - Avaya G700 Installing Manual

Upgrading an existing S8300A to R3.1 using the Web pages

Upgrading Communication Manager software

Setting telnet parameters

●
Remastering the hard drive and installing the upgrade software
●
Verifying software version
●
Copying files to the S8300
●
Configuring network parameters
●
Verifying connectivity
●
Procedure One: Restoring data backup (if upgrading from a Pre-1.2 release)
●
Procedure Two: Restoring data backup (If upgrading from R1.2.x through 2.x)
●
Verifying the time, date, and time zone
●
Installing post-upgrade Communication Manager service pack file from your laptop
●
page 269
Verifying media server configuration
●
Installing the updated license file
●
Installing the new authentication file, if any
●
Saving translations (if not using IA770 and S8300 is not an LSP)
●
Verifying operation
●
Setting telnet parameters
The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as two key presses. You need to
correct this before you Telnet to the server.
Note:
This procedure is done entirely on your laptop, not on the S8300.
Note:
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Type quit and press Enter to save the setting and close the window.
This procedure resets your Microsoft Telnet defaults and does not need to be done each time
you use Telnet.
258 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 258
on page 264
on page 265
on page 267
on page 268
on page 275
on page 276
on page 278
on page 280
on page 259
on page 279
on page 271
on page 272
on
on page 280