Setting Up The Controller List For The G700 - Avaya G700 Installing Manual

Media gateway and media server
Hide thumbs Also See for G700:
Table of Contents

Advertisement

Manual installation of a new G700 without an S8300
To run the ping command
1. At the MG-???-n(config)# prompt, type ping mgp <IP_address>
where <IP_address> is the address of an S8300, S8500, or S8700 Media Server, the VoIP
engine, or any other functioning endpoint accessible on the customer's LAN. It is
recommended to ping endpoints on both the same subnet and a different subnet.
Ping results appear on the screen, similar to the following example.
Ping MGP results
MG-???-1(configure)# ping mgp 135.122.49.55
PING 135.122.49.55: 56 data bytes
64 bytes from 135.122.49.55: icmp_seq=0. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=1. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=2. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=3. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=4. time=0. ms
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
2. Check that the same number of packets transmitted were also received.
3. Type ping voip v0 <IP_address>
<IP_address> is the address of the G700, or any other functioning endpoint on the
customer's LAN.
Ping results appear on the screen, similar to the following example.
Ping VoIP results
MG-???-1(configure)# ping voip v0 135.122.49.55
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0 packet loss
round-trip(ms) min/avg/max = 0/1/0

Setting up the controller list for the G700

To complete the configuration of the G700 media gateway, you need to administer a list of
primary and alternate controllers. This list begins with the IP address of the primary controller. In
the event that the G700 media gateway loses contact with its primary controller, it will seek to
re-register with the primary controller first, then with the other controllers on this list. The other
controllers are S8500 or S8700/S8710 media servers that can act as the primary controller, or
S8300 media servers configured as Local Survivable Processors (LSPs).
556 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300

Table of Contents