Restoring The 4600-Series Phone Configuration File, If Any; Upgrade The G700 Firmware; Manually Upgrading G700 Firmware - Avaya G700 Installing Manual

Manual upgrade of an existing S8300B and G700 to R3.1

Restoring the 4600-series phone configuration file, if any

If you copied a 4600-series phone configuration file to the /var/home/ftp/pub directory prior to
the upgrade, you should restore it after the upgrade. However, before you restore the file, be
sure you have downloaded the appropriate IP phone firmware.
1. At the Linux command line, type cd ~ftp/pub, and press Enter.
2. At the prompt, type cp 46xxsettings.txt /tftpboot, and press Enter.
The 4600-series phone settings file is now restored to the /tftpboot directory.

Upgrade the G700 Firmware

This section describes how to upgrade firmware on the components of the G700, including the
Media Gateway Processor (MGP), the P330 Stack Processor, and any installed media modules.

Manually upgrading G700 firmware

Conduct the following manual procedures to update the firmware running on the G700 Media
Gateway processors and media modules:
G700 Pre-Upgrade Tasks
1. Verifying the contents of the tftpboot directory
2. Determining which firmware to install on the G700
G700 Upgrade Tasks
1. Installing new firmware on the P330 stack processor
2. Installing new firmware on the G700 Media Gateway Processor
3. Installing new firmware on the media modules
4. Installing new firmware on other G700 media gateways
702 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 703
on page 704
on page 706
on page 706
on page 708
on page 711