Chapter 11: Manual Upgrade Of An Existing S8300A And G700 To R3.1; About Upgrading An Existing S8300A To R3.1 - Avaya G700 Installing Manual

Media gateway and media server

Hide thumbs Also See for G700:

Table of Contents

Chapter 11: Manual upgrade of an existing S8300A

This chapter covers the procedures to upgrade the Communication Manager software to

release 3.1 on an installed Avaya S8300 Media Server, version A. The procedures to upgrade

the G700 firmware use CLI commands instead of the Upgrade Tool. The current

Communication Manager release can be any pre-2.1 release. These procedures require

replacing version A of the S8300 with version B. This chapter also covers the procedures to

upgrade the firmware on an installed Avaya G700 Media Gateway.

This chapter assumes that the currently installed S8300 is version A. If the

currently installed S8300 is version B, follow the upgrade procedures in

12: Manual upgrade of an existing S8300B and G700 to

The B version of the S8300 shows a "B" on the faceplate (see

faceplate) — the version is not indicated on the faceplate of the A version.

Figure 53: S8300B version faceplate

The S8300 version can also be determined with the SAT command, list config all. The

B version is listed as S8300B. The A version is listed as S8300.

The S8300 can be configured as either the primary controller or as a local survivable processor

(LSP). When the S8300 is an LSP, the primary controller running Avaya Communication

Manager can be either another S8300 or an Avaya S8500 or S8700/S8710 Media Server.

and G700 to R3.1

Figure 53: S8300B version

Issue 9.1 June 2006