Installing Tftp Server Or Obtaining Usb Cd-Rom Drive; Before Going To The Customer Site - Avaya G700 Installing Manual

Before going to the customer site

The procedures in this section should be completed before going to the customer site or before
starting a remote installation.
Do the following procedures:

Installing TFTP server or obtaining USB CD-ROM drive

●
!
Important:
If the new S8300B that you will be installing has Communication Manager
Important:
software installed on its hard drive, you must use an external USB CD-ROM drive
instead of the TFTP server on your laptop. See
page 228 for more information.
Filling in the EPW, if upgrading from release 1.1
●
Planning forms provided by the project manager
●
Getting the serial number of the G700, if necessary
●
Checking the number of allocated ports
●
Identifying the FTP server for backing up data
●
Obtaining S8300 software and G700 firmware
●
Obtaining service pack files
●
If using IA770, checking stored messages size, obtaining service pack (or RFU) and
●
language files
Completing the RFA process (obtaining license and authentication files)
●
Installing TFTP server or obtaining USB CD-ROM drive
Upgrading Communication Manager on an S8300 to release 3.1 normally requires remastering
the S8300B hard drive. After remastering the drive, the remastering program looks for the
Communication Manager software files on:
An external USB CD-ROM drive, or
●
The laptop, if a TFTP server is installed
●
You must have either the Avaya TFTP server software installed on your laptop or take a USB
CD-ROM drive to the site. If you do not already have the Avaya TFTP server installed on your
laptop, you can obtain the software from the Avaya Support website and install it as described in
Appendix D: Install the Avaya TFTP
on page 233
on page 234
server.
Before going to the customer site
on page 229
Accessing the Server CD
on page 230
on page 230
on page 231
on page 231
on page 231
on page 232
on
on page 236
Issue 9.1 June 2006 229