■ Selecting the mode
q Push [V/M/C] repeatedly to sequen-
tially select the VFO mode, memory
mode, call channel mode or weather
channel mode*.
* Only for the U.S.A. version transceiver.
w Rotate [DIAL] to change the fre-
quency or select a desired channel.
D VFO mode
The VFO mode is used to set the desired frequency.
• VFO mode display
What is VFO?
VFO is an abbreviation of Variable Frequency Oscillator. Fre-
quencies for both transmitting and receiving are generated
and controlled by the VFO.
D Memory mode
[DIAL]
Memory mode is used for opera-
tion on memory channels which
store programmed frequencies.
• "
" appears when memory mode
is selected.
• Only programmed memory chan-
nels can be selected.
• Enter the channel number directly to select the desired memory
channel. (p. 30)
D Call channel mode
Select a call channel to operate
on one of your two most often-
used frequencies.
• "C0" or "C1" appears instead of the
memory channel number when the
Call channel mode is selected.
D Weather channel mode*
There are 10 weather channels
for monitoring weather broad-
casts from NOAA (National
Oceanic and Atmospheric Ad-
ministration).
* Only for the U.S.A. version transceiver.
BASIC OPERATION
• Memory mode display
Appears
• Call channel display
• Weather channel display
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
18
Need help?
Do you have a question about the IC-T70A and is the answer not in the manual?
Questions and answers
How to set aicom t70a to repeater
To set the Icom IC-T70A to repeater mode:
1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.
This answer is automatically generated