Foreword; Explicit Definitions - Icom IC-T70A Instruction Manual

Vhf/uhf dual band fm transceiver
Hide thumbs Also See for IC-T70A:
Table of Contents

Advertisement

FOREWORD

Thank you for purchasing this fine Icom product. The IC-
T70A/T70E
vhf
uhf dual band fm transceiver
/
and build with Icom's superior technology and craftsmanship.
With proper care, this product should provide you with years
of trouble-free operation.
We want to take a moment of your time to thank you for mak-
ing your IC-T70A/T70E your radio of choice, and hope you
agree with Icom's philosophy of "technology first." Many hours
or research and development went into the design of your
IC-T70A/T70E.

EXPLICIT DEFINITIONS

WORD
Personal death, serious injury or an ex-
R DANGER!
plosion may occur.
Personal injury, fire hazard or electric
R WARNING!
shock may occur.
CAUTION
Equipment damage may occur.
Recommended for optimum use. No risk
NOTE
of personal injury, fire or electric shock.
i
is designed
DEFINITION
FEATURES
❍ Dust-protection/Splash-resistant construc-
tion (IP54*)
* Only when the battery pack/case, antenna and jack cover
are attached.
❍ Built in VOX circuit enabling the VOX opera-
tion* (voice operated transmission)
* To use the VOX operation, an optional headset and a plug
adapter cable are additionally required.
700 mW* AF power with BTL (bridge-tied
load) amplifier
*At 10% distortion with a 16
IMPORTANT
READ ALL INSTRUCTIONS
before using the transceiver.
SAVE THIS INSTRUCTION MANUAL—
instruction manual contains important operating instructions
for the IC-T70A/T70E.
Ω
load (internal speaker)
carefully and completely
This

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IC-T70A and is the answer not in the manual?

Questions and answers

Abdulhamid
February 21, 2025

How to set aicom t70a to repeater

1 comments:
Mr. Anderson
February 21, 2025

To set the Icom IC-T70A to repeater mode:

1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.

This answer is automatically generated

This manual is also suitable for:

Ic-t70e

Table of Contents

Save PDF