Icom IC-T70A Instruction Manual page 11
Vhf/uhf dual band fm transceiver
Hide thumbs
Also See for IC-T70A:
- Service manual (41 pages) ,
- Instruction manual (11 pages) ,
- Product review (3 pages)
Table of Contents
Advertisement
r VOLUME CONTROL [VOL]
➥ Adjust the audio volume level. (p. 16)
➥ During set mode operation, rotate to select the options.
(p. 51)
t PTT SWITCH [PTT]
➥ Push and hold to transmit, release to receive. (p. 23)
For IC-T70E only
➥ Push briefly, then push and hold to transmit a 1750 Hz
tone burst. (p. 28)
y EXTERNAL DC IN JACK [DC IN]
➥ Connects the supplied wall charger, BC-167S, to charge
the attached battery pack, BP-264. (p. 12)
• The transceiver can charge only the BP-264 Ni-MH battery
pack. Charging the BP-265 Li-Ion battery pack requires the
BC-193 desktop charger.
➥ Connect an external DC power supply through the op-
tional CP-12L, CP-19R or OPC-254L for external DC
operation. (p. 15)
PANEL DESCRIPTION
D Keypad
➥ Push to input numbers for frequency input or memory
channel selection.
➥ While continuing to push [PTT], push the key to send the
DTMF code. (pp. 66, 67)
• [0]–[9] send "0"–"9," [A](SET) sends "A," [B](BAND) sends "B,"
[C](H/M/L) sends "C," [D](V/M/C) sends "D," [M](DUP) sends
"M (E)" and [#](T.SCAN) sends "# (F)."
POWER KEY [ ]
➥ Push and hold for 1 sec. to turn the transceiver
power ON or OFF. (p. 16)
VFO/MEMORY/CALL • SELECT MEMORY WRITE KEY
[V/M/C] • [S.MW](V/M/C)
➥ Push to select the VFO mode, memory mode, call
channel mode or weather channel mode*. (pp. 18,
29, 30, 72)
* Only for the U.S.A. version transceiver.
➥ Push and hold for 1 sec. to enter select memory
write mode. (p. 31)
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
4
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-T70A and is the answer not in the manual?
Questions and answers
How to set aicom t70a to repeater
To set the Icom IC-T70A to repeater mode:
1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.
This answer is automatically generated