Selecting A Memory Channel - Icom IC-T70A Instruction Manual
Vhf/uhf dual band fm transceiver
Hide thumbs
Also See for IC-T70A:
- Service manual (41 pages) ,
- Instruction manual (11 pages) ,
- Product review (3 pages)
Table of Contents
Advertisement
■ Selecting a memory channel
D Using [DIAL]
q Push [V/M/C] to select the memory mode.
• Pushing [V/M/C] toggles between the VFO mode, the memory
channel mode, call channel mode and weather channel mode*.
* Only the U.S.A. version transceiver.
w Rotate [DIAL] to select a desired memory channel.
• Only programmed channels are displayed.
[DIAL]
Appears
Rotate [DIAL] to select
the memory channel.
MEMORY/CALL CHANNELS
D Using the Numeral keys
q Push [V/M/C] to select the memory mode.
• Pushing [V/M/C] toggles between the VFO mode, the memory
channel mode, call channel mode and weather channel mode*.
* Only the U.S.A. version transceiver.
w Use the number keys to enter 3 digits to select a desired
memory channel.
• The blank channels are also selectable.
• Example— selecting memory channel "25"
Push [V/M/C], then push [0], [2], [5].
Numeral
keys
6
Appears
The entered memory
channel is selected.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
30
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-T70A and is the answer not in the manual?
Questions and answers
How to set aicom t70a to repeater
To set the Icom IC-T70A to repeater mode:
1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.
This answer is automatically generated