Memory Bank Scan - Icom IC-T70A Instruction Manual

7
SCAN OPERATION

■ Memory bank scan

IMPORTANT!: To perform a memory bank scan, 2 or more
bank channels MUST be programmed, otherwise the scan
will not start.
q Select the memory bank mode.
➥ Push [V/M/C] to select the memory mode.
➥ Push [BAND] to enter the memory bank selection
mode.
➥ Rotate [DIAL] to set a desired bank (A to Z), then push
[BAND].
w Set the squelch level.
e Push and hold [SCAN](H/M/L) for 1 sec. to enter the scan
type selection mode.
[DIAL]
All bank scan
Bank link scan
See page 56 for details of
the bank link programming.
45
Push and hold
for 1 sec.
Rotate
Bank scan
Selectable from "A" to "Z,"
if programmed. (p. 32)
Duplex scan
r Rotate [DIAL] to select a desired scanning type.
• Select "ALL" for all bank scan, "b-LInk" for bank link scan or
x x
"bAnk- " for bank scan (
groups are displayed.), "dUP" (appears only when duplex opera-
tion is set) for duplex scan.
t Push [SCAN](H/M/L) to start the scan.
• The scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also re-
sumes scanning.
• Push [V/M/C] to stop the scan.
• Push [BAND] to change the bank during a bank scan.
• While continuing to push [SCAN](H/M/L) in step e, rotate
[DIAL] to select a desired scanning type, then release the key
also starts the scan.
During all bank/bank link scan
Memory bank scan skips any memory channels in the se-
lected bank that are set to "SKIP" or "PSKIP."
Memory bank scan stops at the first channel when all
channels in a bank are set to "SKIP" or "PSKIP."
= A to Z; only programmed bank
During bank scan