Selecting The Frequency Selecting Mode; D Vfo Mode; D Memory Mode; D Call Channel Mode - Icom ID-50A Basic Manual

■ Selecting the Frequency Selecting mode

D VFO mode

Rotate [DIAL] to set an operating frequency.
Memory mode
D
Select a Memory channel where an operating frequency and other parameters are saved.
L In the Memory mode,

D Call Channel mode

Select a Call Channel to recall your most often used frequencies quickly.
Weather Channel mode (For only the ID-50A)
D
Weather Channels are used for monitoring Weather Channels from the National
Oceanographic and Atmospheric Administration (NOAA) broadcasts.
1. Select a mode.
L Information
• Push [V/MHz] to select the VFO mode.
• In the VFO mode, push [V/MHz] to select the 1 MHz tuning step.
• Push [MR] to select the Memory mode.
• Hold down [CALL] for 1 second to select the Call Channel mode.
• For only the ID-50A, push [MR] in the Memory mode to select the Weather Channel
mode.
2. Rotate [DIAL] to select an operating frequency or a channel.
VFO mode

■ DR function operation

Using the D-STAR Repeater (DR) function, you can easily
select the entered repeaters and Your call signs by rotating
[DIAL]. You can make not only a repeater call but also a
simplex call.
Hold down [DR] for 1 second.
• Displays the DR screen.
L Hold down [DR] again to cancel the DR function.
L See D-STAR GUIDE (p. 41) for the DR function details.
and the Memory Channel number are displayed.
Memory mode
BASIC OPERATION
Call Channel
mode
3
Weather Channel
mode
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
14