Icom IC-T70A Instruction Manual page 70
Vhf/uhf dual band fm transceiver
Hide thumbs
Also See for IC-T70A:
- Service manual (41 pages) ,
- Instruction manual (11 pages) ,
- Product review (3 pages)
Table of Contents
Advertisement
9
SET MODES
D Monitor key action (MONI)
The monitor key, [MONI](BAND), can be set as a 'sticky' key.
When set to the sticky condition, each push of [MONI](BAND)
toggles the monitor function ON or OFF.
• PUSH
: Push and hold [MONI](BAND) to monitor the fre-
quency.
• HOLd
: Push and hold [MONI](BAND) for 1 sec. to monitor the
frequency and push again to cancel it.
D Dial speed acceleration (DIAL S)
The dial speed acceleration automatically speeds up the tun-
ing dial speed when rotating [DIAL] rapidly.
• OFF
: The dial speed acceleration is turned OFF.
• On
: The dial speed acceleration is tuned ON.
63
D Memory name (NAME)
The memory name is displayed during memory mode, or the
memory bank name is displayed during memory bank selec-
tion.
(default: PUSH)
• OFF
• On
D Scan name (S NAME)
The programmed scan, programmed link scan or bank name
is displayed during scan type selection.
(default: On)
• OFF
• On
: The frequency of the selected memory channel is dis-
played.
: The pre-programmed memory name or memory bank
name is displayed.
: The programmed scan, programmed link scan or bank
name is not
displayed.
: The programmed scan, programmed link scan or bank
name is
displayed.
(default: OFF)
(default: On)
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-T70A and is the answer not in the manual?
Questions and answers
How to set aicom t70a to repeater
To set the Icom IC-T70A to repeater mode:
1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.
This answer is automatically generated