Icom IC-T70A Instruction Manual page 80

Vhf/uhf dual band fm transceiver

Hide thumbs Also See for IC-T70A:

Service manual (41 pages)

Instruction manual (11 pages)

Product review (3 pages)

Table Of Contents

Table of Contents

OTHER FUNCTIONS

D Weather alert function (continued)

t Set the desired stand-by condition.

• Select the VFO mode, memory mode or call channel mode.

• Scan or priority watch operation can also be selected.

y When the alert is detected, a beep sounds and the follow-

ing indication is displayed.

Shows above indications alternately.

u Turn the weather alert function OFF in the Set mode.

NOTE: While receiving a signal on a frequency other than

the Weather alert frequency, the receiving signal will be

interrupted momentarily approximately every 5 seconds

when the Whether alert function is ON. These interrup-

tions cease when the Weather alert function is turned

OFF.

Table of Contents

Need help?

Do you have a question about the IC-T70A and is the answer not in the manual?

Questions and answers

Abdulhamid

February 21, 2025

How to set aicom t70a to repeater

1 comments:

Mr. Anderson

February 21, 2025

To set the Icom IC-T70A to repeater mode:

1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.

This answer is automatically generated