Full/Band/Programmed Scan - Icom IC-T70A Instruction Manual

■ Full/band/programmed scan

q Push [V/M/C]
to select the VFO mode
• Push [BAND] to select a desired frequency band.
w Set the squelch level.
e Push and hold [SCAN](H/M/L) for 1 sec. to enter the scan
type selection mode.
r Rotate [DIAL] to select a desired scanning type.
• Select "ALL" for full scan, "bAnd" for band scan, "P-LInk x" for
programmed link scan (x= 0 to 9), "PROG
xx
scan ( = 0 to 24; only programmed scan edge numbers are
displayed), "dUP" (appears only when duplex operation is set)
for a duplex scan.
[DIAL]
Full scan
Band scan
Programmed link scan
.
xx
" for programmed
Push and hold
for 1 sec.
Rotate
Programmed scan
Selectable from "0" to "24,"
if programmed. (p. 43)
Duplex scan
Selectable from "0" to "9."
See page 57 for details
of the programming.
t Push [SCAN](H/M/L) to start the scan.
• The scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also re-
sumes scanning.
• Push [V/M/C] to stop the scan.
• Push [BAND] to change the band during band scan, or change
the scan edge during programmed scan/program link scan.
• While continuing to push [SCAN](H/M/L) in step e, rotate
[DIAL] to select a desired scanning type, then release the key
also starts the scan.
During full/band scan
The scan link name or scan name can be displayed instead
of "P-LInk x" for program link scan (x= 0 to 9), "PROGxx" for
programmed scan (xx= 0 to 24) when scan link name or scan
name is programmed and set to ON in the Initial set mode.
Scan link name or scan name is not displayed during scan.
SCAN OPERATION
During programmed scan
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
42